1 Maya 3D Tutorial Handle NURBS seams Thu Oct 09, 2014 4:10 am
Admin
Admin
[You must be registered and logged in to see this image.]
A build a sphere and a circle with a reasonable increase in the number of segments that we have to do is to take the ball and round with pick up
\
2 According need to select the ISO cable to the cutting surface
\
3
\
4. Plus a few little fragments, fragments on the number of required patches docking words will lead to model the deformation
\
5 is also coupled to the same number of segments in the face sheet connected to the
\
6 Select 2 and patch butt
\
7 reconstruction surface, pay attention to the parameters of the surface reconstruction
\
8 Select the ISO off the surface in order to facilitate the other side stitching
\
9 Continue stitching, reconstruction and disconnect
\
10
\
11 Continue the above steps
\
12. Right now the side seam stitching tool can be used to sew, you can also adjust the points so that the seam as small as possible
\
13.
\
After adjustment of the surface 14
\
Suture tool with global
Note Parameters
\
Parameters, is not enough, then you can increase the
\
Rendering results]
A build a sphere and a circle with a reasonable increase in the number of segments that we have to do is to take the ball and round with pick up
\
2 According need to select the ISO cable to the cutting surface
\
3
\
4. Plus a few little fragments, fragments on the number of required patches docking words will lead to model the deformation
\
5 is also coupled to the same number of segments in the face sheet connected to the
\
6 Select 2 and patch butt
\
7 reconstruction surface, pay attention to the parameters of the surface reconstruction
\
8 Select the ISO off the surface in order to facilitate the other side stitching
\
9 Continue stitching, reconstruction and disconnect
\
10
\
11 Continue the above steps
\
12. Right now the side seam stitching tool can be used to sew, you can also adjust the points so that the seam as small as possible
\
13.
\
After adjustment of the surface 14
\
Suture tool with global
Note Parameters
\
Parameters, is not enough, then you can increase the
\
Rendering results]